The 2nd set of cages built for our caddy.

After seeing the two sets of cages I made for customers my darling wife was questioning why her cages weren’t quite as nice for out TWO great danes.

In an effort to make it as nice as possible i went all in and stripped the back of the van out completely and added a full carpet lining, electric vent fan, escape doors, better locks and a eye catching colour scheme.

It has TWO large cages so one dog can travel in the front cage and the 2nd dog can travel in the back.

There is another two much smaller cages which are sized to allow the soft crate which is used at dog shows to be put in the bttom cage with other stuff going next to it with a good sized space above it for stuff.

You will see the large door at the back has 4 hinges. This is to allow me to fit the two smaller doors upper and lower into the same space. There is also small steel plates all at the same height on all 3 bulkheads. This means I can fit in a floor to split this one giant cage into two large cages

Fitting of the ventilation fan brought in a few challenges but i’ve got a 3D printed and i’m not afraid to use it. See more HERE

back doors built and sized for the soft crate

Lets have a go at the carpetting. how hard can it be?

Front cage with the door allowing the van door to be left open for ventilation

The grid behind the drivers seat to allow free passage of air and biscuits, mainly biscuits

daphne isn't overly sure if she fits through that door

Dura in the sun. This dog is solar powered

Top cage. For tiny dogs and stuff. Mostly stuff in our case

This tells you nothing useful, but you like it

Escape door from the two small rear cages. Mostly used to load shopping